Cygnett ChargeUp Pro 10K manual

Cygnett ChargeUp Pro 10K
7.1 · 2
PDF user manual
 · 1 page
user manualCygnett ChargeUp Pro 10K
Recharge your ChargeUp Pro
To recharge your ChargeUp Pro, connect it to a computer, car-charger or wall-charger via the Micro-USB input (E), using the Micro-USB cable provided.
When charging, the LCD display (B) will flash, indicating remaining charge.
Charge your device
Using your device’s USB charging cable (not included), connect your device to either the USB-A (C) or USB-C output (D). Press the power button (A) once to
start charging your device. Your device should indicate that it has begun to charge. The LCD display (B) will now indicate your ChargeUp Pro’s remaining
charge. Repeat steps above to charge a second device. When you are finished charging your device/s, detatch them from your ChargeUp Pro.
It will turn off automatically.
LCD charge indicator
To check your ChargeUp Pro’s remaining charge, press the power button (A) once. The LCD display (B) will show the remaining charge from 0 to 100.

ChargeUp Pro 10K

10,000 mAh Portable Powerbank

Please note that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to connect the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation
between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.
Important safety instructions
Please read and follow these instructions carefully and retain for your records.
Please read all warnings for your safety and optimal user experience.
1. Never leave a charging battery unattended.
2. Do not expose the ChargeUp to excess humidity or liquids. It should be stored in a cool, dry place
when not in use.
3. Do not damage or puncture the casing of the ChargeUp. This may cause over-heating,fire or
an explosion.
4. Do not expose the ChargeUp to sources of heat, including radiators, stoves, or fires. Do not expose to
ambient temperatures above 40°c, such as in a car on hot day, or in direct sunlight. Failure to do so
may cause over-heating, fire, or explosion.
5. Do not use in a strong electrostatic or electromagnetic environment, including near microwaves as this
may shorten the device’s life.
6. If ChargeUp emits an odour, excessive heat or becomes discoloured or distorted, please discontinue
use immediately.
7. Refer all servicing to qualified service personnel, which is required if ChargeUp is damaged in any way,
is exposed to liquid or does not operate normally. Please do not attempt to service or open the device.
This may cause over-heating, fire or an explosion.
8. If the battery electrolyte makes contact with skin or eyes, rinse thoroughly with water immediately and
consult a doctor. The electrolyte is flammable and reaction with air may cause the chemicals to ignite,
resulting in fire.
9. At the end of the device’s life, please dispose of this product at a battery recycling station. It is not
suitable for domestic waste disposal.
10. If a new ChargeUp is not used for a period of three months or more, its battery capacity will be
reduced, but will restore to normal capacity after 3-4 charge and discharge cycles.
A - Power button
B - LCD display
C - USB-A output
D - USB-C output
E - Micro-USB input
Product specifications
Battery type: Lithium battery
Micro-USB Input: DC 5V - 2.0A (MAX)
USB-C Input: DC 5V - 3.0A (MAX)
USB-C Output: DC 5V - 3.0A (MAX)
USB-A Output: DC 5V - 3.0A (MAX), 9V - 2A, 12V - 1.5A (QC3.0)
Total Output: 18W (MAX)
Operating Temperature: 0˚C - 40˚C
Risk of explosion if battery is replaced
by an incorrect type. Dispose of used
batteries according to the instructions.
Do not store cable with both connectors plugged
into powerbank as this may short circuit
powerbank and stop it from working.

User manual

View the manual for the Cygnett ChargeUp Pro 10K here, for free. This manual comes under the category Power banks and has been rated by 2 people with an average of a 7.1. This manual is available in the following languages: English. Do you have a question about the Cygnett ChargeUp Pro 10K or do you need help? Ask your question here

Need help?

Do you have a question about the Cygnett ChargeUp Pro 10K and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Cygnett ChargeUp Pro 10K owners to provide you with a good answer.

Homer • 24-6-2022 No comments

How long does it take to charge the powerbank

Answer this question
Ros Cumming • 23-4-2022 No comments

My power pack is showing a flashing code of 118 on the screen when I plug it in to charge, what can I do?

Answer this question

Number of questions: 2

Cygnett ChargeUp Pro 10K specifications

Below you will find the product specifications and the manual specifications of the Cygnett ChargeUp Pro 10K.

Brand Cygnett
Model ChargeUp Pro 10K
Product Power bank
Language English
Filetype manual_type_manual (PDF)

Questions & answers

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Cygnett ChargeUp Pro 10K below.

Is your question not listed? Ask your question here

No results