1 2 3 4 5
6
Emptying condensation
Empty container after each drying operation!
1. Pull out condensation container keeping it horizontal.
2. Pour out condensation.
3. Always push container in fully until it clicks into place.
If Empty water flashes in the display panel a What to do if..., Page 10.
Cleaning the fluff filter
Clean the fluff filter after each drying operation.
1. Open the door, remove fluff from door/door area.
2. Pull out and fold open the fluff filter.
3. Remove the fluff (by wiping the filter with your hand).
If the fluff filter is very dirty or blocked, rinse with warm water and dry
thoroughly.
4. Close and reinsert the fluff filter.
Switching off the dryer
Turn the programme selector to Off.
Do not leave laundry in the dryer.
Removing the laundry
The automatic anti-crease function causes the drum to move at specific intervals, the washing remains
loose and fluffy for an hour (two hours if the additional Less Ironing function is also selected-depending
on model).
... and adapt to individual requirementsNever start the dryer if it is damaged!
Inform your after-sales service.
Inspecting the
dryer
Sorting and loading laundry
Remove all items from pockets.
Check for cigarette lighters.
The drum must be empty prior to loading.
See programme overview on page 7.
See also separate instructions for “Woollens basket”
(depending on model)
Your new dryer
Congratulations - You have chosen a modern, high-quality Siemens
domestic appliance.
The condensation dryer is distinguished by its economical energy
consumption.
Every dryer which leaves our factory is carefully checked to ensure
that it functions correctly and is in perfect condition.
Should you have any questions, our after-sales service will be pleased
to help.
Disposal in an environmentally-responsible manner
Dispose of packaging in an environmentally-responsible manner.
This appliance is labelled in accordance with the European
guideline
2002/96/EG on waste electrical and electronic equipment - WEEE.
The guideline provides an EU-wide framework for the return and
recycling of old appliances.
For further information about our products, accessories, spare parts
and services, please visit: www.siemens-home.com
Intended use
Preparing for
installation, see Page 8
Selecting and adjusting the programme
Drying
Condensation container
Control panel
ʋ for domestic use only,
ʋ only to be used for drying fabrics that have been
washed with water.
Do not leave children unsupervised near the dryer.
Keep pets away from the dryer.
Select the drying programme ...Press the Start/Stop buttonMake sure your hands are dry.
Hold the plug only.
Connecting the
mains plug
Drying
Information on laundry ...
Labelling of fabricsFollow the manufacturer's care information.
( Drying at normal temperature.
'cDrying at low temperature a also select Low Heat.
)cDo not machine dry.
Observe safety instructions without fail a Page 11!
Do not tumble-dry the following fabrics for example:
– Impermeable fabrics (e.g. rubber-coated fabrics).
– Delicate materials (silk or curtains made from synthetic material) a they may crease
– Laundry contaminated with oil.
Drying tips– To ensure a consistent result, sort the laundry by fabric type and drying programme.
– Always dry very small items (e.g. baby socks) together with large items of laundry (e.g. hand
towel).
– Close zips, hooks and eyelets, and button up covers.
Tie fabric belts, apron strings, etc. together
– Do not over-dry easy-care laundry a risk of creasing!
Allow laundry to finish drying in the air.
– Do not dry woolens in the dryer, only use to freshen them up a Page 7, Woollens Finish
Programme (depending on model).
– Do not iron laundry immediately after drying, fold items up and leave for a while a the
remaining moisture will then be distributed evenly.
– Machine-knitted fabrics (e.g. T-shirts or jerseys) often shrink the first time they are dried a
do not use the Cupboard Dry Extra programme.
– Starched laundry is not always suitable for dryers a starch leaves behind a coating that
adversely affects the drying operation.
– Use the correct dosage of fabric softener as per the manufacturer's instructions when
washing the laundry to be dried.
– Use the timer programme for small loads a this improves the drying result.
Environmental protection/energy-saving tips– Before drying, spin the laundry thoroughly in the washing machine a the higher the spin
speed the shorter the drying time will be (consumes less energy), also spin easy-care
laundry.
– Put in, but do not exceed, the maximum recommended quantity of laundry a
programme overview a Page 7.
– Make sure the room is well ventilated during drying.
– Do not obstruct or seal up the air inlet.
– Keep the air cooler clean a page 6 “Care and cleaning”.
Drum
All buttons are sensitive and only
need to be touched lightly.
Only operate the dryer with
the fluff filter inserted!
Air inlet
Fluff filter
Drum interior light
(depending on model)
Maintenance
flap
Care and cleaning
Dryer housing, control panel, air cooler, moisture sensors– Wipe with a soft, damp cloth.
– Do not use harsh cleaning agents and solvents.
– Remove detergent and cleaning agent residue immediately.
– During drying, water may collect between the door and seal.
This does not affect your dryer's functions in any way.
Clean the air cooler 5 - 6 times a year
or if Clean filter flashes after cleaning the fluff filter.
Air cooler – Allow the dryer to cool.– Residual water may leak out, so place an absorbent towel underneath the maintenance door.1. Unlock the maintenance door.
2. Open the maintenance door fully.
3. Turn both locking levers towards each another.
4. Pull out the air cooler.
Do not damage the air cooler.Clean with warm water only. Do not use any hard or sharp-edged objects.5. Clean the air cooler thoroughly,
Allow to drip dry.
6.
Clean the seals.7. Re-insert the air cooler,
with the handle facing down.8. Turn back both locking levers.
9. Close the maintenance door until the lock clicks into place.
Moisture sensorsThe dryer is fitted with stainless steel moisture sensors. The sensors
measure the level of moisture in the laundry. After a long period of
operation, a fine layer of limescale may form on the sensors.
1. Open the door and clean the moisture sensors with a damp sponge
which has a rough surface.
Do not use steel wool or abrasive materials.
Programme end once lights up in the display.
Interrupt programme removing or adding laundry.
The drying cycle can be interrupted for a brief period so that laundry may be added or removed.
The programme selected must then be resumed and completed.
Never switch the dryer off before the drying process has ended.
Drum and door may be hot!
1. Open door, the drying process is interrupted.
2. Load or remove laundry and close door.
3. If required, select a new programme and additional functions.
4. Press the Start/Stop button.
Contents Page
ʋ Preparation . . . . . . . . . . . . . . . . . . . . . . 2
ʋ Setting the programmes . . . . . . . . . . . . . 2
ʋ Drying . . . . . . . . . . . . . . . . . . . . . . . . 3/4
ʋ Information on laundry . . . . . . . . . . . . . . 5
ʋ Care and cleaning . . . . . . . . . . . . . . . . . 6
ʋ Programme overview . . . . . . . . . . . . . . . . 7
ʋ Installation . . . . . . . . . . . . . . . . . . . . . . . . 8
ʋ Frost protection/transport . . . . . . . . . . . . 8
ʋ Technical data . . . . . . . . . . . . . . . . . . . . 9
ʋ Optional accessories . . . . . . . . . . . . . . . . 9
ʋ What to do if... / After-sales service . . . . 10
ʋ Safety instructions . . . . . . . . . . . . . . . . 11
Additional
functions
Programme selector Time
remaining
Display panel
Clean the fluff filter and/or air cooler a page 4/6.
Empty the condensation container.
Service displays
Clean filter
Empty water
End of programme in 1*-24 hours (Press button several times if required)
(*depending on the selected programme, e.g. duration 1:54h a 2h. Can always be selected to the
next full hour.
ˎ Finish
in
ˎ Low Heat
Reduced temperature for delicate fabrics ' that require a longer drying time; e.g. for polyacrylics, polyamide, elastane or acetate.ˎ Less Ironing
Reduces creasing and extends the anti-creasing phase once the program has ended.ʋ Buzzer Select On/Off for a acoustic signal at end of programme.
Only when switched off!
Need help?
Do you have a question about the Siemens and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Siemens owners to provide you with a good answer.
Number of questions: 0